Positioning A Dehumidifier - Dri-Eaz LGR 6000Li Manuel D'utilisation

FIG A: PARTS IDENTIFICATION
FRONT
Power cord and
drain hose
storage.
Humid air inlet.
Air filter.
Front panel. Remove to
access the pump and
coils for cleaning. See
Fig. B.
Drain hose
REAR
quick-connect.
Integrated handle. Use the
red lever to lock handle
upright for use or down
for loading or storage.
Control panel.
Power cord
socket.
Drain hose quick-
connect.
Model serial
number label
Process (dehumidified)
air outlet.
upright and let it stand for at least 30 minutes before
turning it on.
108259F #103614 (F600)

Positioning a Dehumidifier

For best results, operate your dehumidifier in
an enclosed area. Close all doors and windows
to maximize the unit's water removal efficiency.
Place your dehumidifier away from
obstructions and keep it away from anything
that could obstruct airflow into and out of the
unit.
Extend handle
Release the handle by rotating red locking
lever outward, then lift handle up into place.
Rotate red lever back into locked position to
secure handle in operating position.
NOTICE: Do not use the extended handle to lift
the unit off the ground horizontally. Do not use
the extended handle as an attachment point to
strap the unit in a vehicle for transport. These
uses will place undue strain on the handle
attachment points in the housing.
Set up drain hose
This unit automatically pumps out water on a
regular basis. This dehumidifier is equipped
with a quick-connect fitting for attachment to
the provided drain hose located in the tray on
top of the unit. Unwrap the entire hose and
place the open end in a sink, drain, bucket or
outdoors – anywhere that water can drain out
safely. If you use a bucket or other container
for water collection, check it regularly to
prevent overflows.
NOTICE: Uncoil and straighten the entire drain
hose. Do not leave any part of the hose coiled
on the unit and do not place the end of the
hose higher than 20 ft. (6 m) above the bottom
of the unit. Also check for kinks or other
obstructions that might restrict the flow of
water. A kink or blockage will cause the unit to
turn off and produce an error message on the
control panel.
Plug in electrical cord
The dehumidifier should be plugged into a
GFCI-protected 115 volt outlet rated for at least
15 amps. Remove the cord from the storage
tray and uncoil it. Always plug the cord firmly
into the unit first, and then plug the other end
into a suitable electrical outlet.
2 Legend Brands, Inc.