Parts Identification; Positioning A Dehumidifier; Operating Your Dehumidifier - Dri-Eaz LGR 7000XLi Guide D'utilisation

PARTS IDENTIFICATION

FIG. A: FRONT
FIG. C: POWER
ATTACHMENT POINT

OPERATING YOUR DEHUMIDIFIER

Set unit upright
NOTICE: Transporting or storing the unit in a
horizontal position is not recommended. When the
machine is placed in a horizontal position, the oil
from the compressor can flow into the refrigerant
coils and reduce the ability of the dehumidifier to
function and possibly damage the unit. If the unit
has been placed in a horizontal position, set it
upright and let it stand for at least 30 minutes before
turning it on.

Positioning a Dehumidifier

For best results, operate your dehumidifiers in an
enclosed area. Close all doors and windows that open to
07-01776D (F412 120V) 2013-01 Warranty 07-00420
Integrated handle.
Folds for storage.
Humid air inlet.
3M™ HAF filter.
Molded pocket
for cord storage.
Control panel.
Process (dehumidified)
air outlet. May be used
with standard 12 in.
rigid or layflat ducting.
Product label and
serial number.
Power cord socket.
2
FIG. B: REAR
Back panel. Remove to
access the pump.
the outside to maximize the unit's water removal
efficiency. Place your dehumidifier away from
obstructions, and keep it away from anything that could
block airflow into and out of the unit. For more
information about creating an optimum drying
environment, contact Dri-Eaz at 800-932-3030.
Set up drain hose
The 7000XLi condensate pump connects to a plastic
drainage hose that is located in the pocket on the side of
the unit. This hose is equipped with a quick-connect
fitting for quick attachment to the provided 40 ft. (12 m)
drain hose. Unwrap the entire hose and place the
unattached end in a sink, drain, bucket or outdoors –
anywhere that water can drain out safely. If you use a
bucket or other container for water collection, check it
regularly to prevent overflows.
Drain hose pocket.
Drain hose location.
Dri-Eaz Products, Inc.