Dri-Eaz LGR 7000XLi Guide D'utilisation page 11

Replace the sensor chip assembly in to the heat exchange
block.
NOTICE! The sensor chip assembly is fragile. Handle with
care at all times. To avoid potentially damaging the
sensor with a static electricity discharge, do not touch the
sensor circuitry and do not place any tape or other
material in contact with the sensor circuitry.
Slide the top cover straight down into place. Make sure the
foam rubber seal strips are in place and are not kinked or
folded.
3 ∕
Replace the front cover. Insert and tighten the front cover in. bolts by hand. After they are hand tight, install and
8
tighten the two back cover bolts.
NOTICE: Be sure housing bolts are properly threaded before tightening. Do not overtighten. Do not use a power
tool!
The unit is now ready for use.
INSPECTING AND CLEANING THE PUMP CHECK VALVE
3 ∕
Remove the five base plate in. bolts. For easier access
8
to these bolts, lay the unit on its back.
NOTICE: Do not place unit on its front, as this might
cause any residual water to drip into sensitive electronic
components.
Remove the front cover as described under "To
disassemble the unit for cleaning coils and heat exchange
block," p. 8.
07-01776D (F412 120V) 2013-01 Warranty 07-00420 11 Dri-Eaz Products, Inc.