Dri-Eaz Evolution LGR F292-A Guide D'utilisation page 6

TROUBLESHOOTING
F A U L T
Unit does not No power to machine.
operate Unit not switched on.
Compressor will Unit needs 5 minutes before restart
not start Overload preventing start up
Blower wheel Obstructed blower.
not turning
Unit operating, Not enough time to dry.
but room not dry Poor air movement in room.
Excessive moist air infiltration.
Unit Room temperature too low
continuously in
defrost mode
Pump does not Stuck float valve
function
Unit collects too Room air is dry.
little water Room temperature is too low.
Airflow through unit is restricted
If the problem you are experiencing is not listed here, call your local distributor or contact the Dri-Eaz Service
Department toll-free at 800-932-3030.
SPECIFICATIONS
Model Evolution LGR F292-A
Type LGR
Refrigerant R-410A
Use weight 92 lbs. | 42 kg
Power 5 amps, 115 volts
Water removal AHAM
70 pts. | 33 liters / day
(80°F/60% RH)
Max process air 160 CFM | 272 CMH
Operating Range 33–100°F | 1–33°C
Air filter 3M HAF filter (part no. F372)
Power cord 25 ft. | 7.6 m
Dimensions 33.5 × 20.7 × 20.7 in.
(H × D × W) 85 × 52.5 × 52.5 cm
Construction Rotomolded polyethylene housing
ETL certified to UL 474 and CSA
Safety
22.2 no. 92
Specifications are subject to change without notice. Some
values may be approximate.
Warranty information is available at www.dri-eaz.com.
07-01480C 2010-01
C A U S E S O L U T I O N
Plug in unit; check power at outlet and at base of unit.
Switch unit on.
Switch off unit, wait 5 minutes before starting.Reduce
room temperature to 90°F (32°C) or less.
Remove duct ring and grill.
Remove obstruction.
Replace duct ring and grill.
Allow more time for drying.
Increase air movement with air movers.
Reduce infiltration.
Increase room temperature.
Clean float valve shaft.
Check humidity with hygrometer.
Increase room temperature.
Check filter and coils; clean as necessary.
6 Dri-Eaz Products, Inc.