Nuova Simonelli MYTHOS 220 Manuel D'instructions page 21

EN
Always use the appliance on a flat, steady surface that is able to support its weight.
Always unplug the machine from the power supply before performing any cleaning or
maintenance operations.
Do not use jets of water or detergents for cleaning.
In the case of machine breakdown or malfunction switch the machine off and do not tamper with it.
For repairs contact only an authorized service center and request use of original spare parts.
Non-observance of the above precautions may make the machine unsafe for future use.
Do not leave the machine switched on when not in use. Unplug the machine when not in use.
Do not obstruct the ventilation and/or heat dissipation openings and/or slits nor introduce
water or any other liquids into same.
Do not obstruct the ventilation and/or heat dissipation openings and/or slits nor introduce
water or any other liquids into same.
Never insert spoons, forks or other utensils into the pouring lip (11) (see Fig. 1 & 7), or
into the coffee grain container (2) (see Fig. 1) for any reason whatsoever while the appli-
ance is operating.
Always switch off the appliance before removing blockages from the pouring lip.
Never place the appliance in water or other liquids.
Should a foreign body stop the motor, switch the machine off immediately and contact an
authorized service center.
Should a foreign body stop the motor, switch the machine off immediately and contact an
authorized service center.
WARNING
Those machines bearing the "EL. MOTOR WITH THERMAL PROTECTION" label are
equipped with device which protects the motor from overheating.
When this device is engaged, do not attempt to operate the machine: isolate the machine
from the power supply and eliminate the cause of the trouble before re-starting.
7. INSTRUCTIONS FOR USE
7.1 PREMISE
This machine is capable of producing very precise doses, since it bases itself on the time of
the grind. It is however necessary to fine tune the machine before starting to work, above
all deciding the blend of coffee (lighter or darker roast) and the grade of grind. You then
proceed to programming the time of grind for each dosage, weighing the ground product.
While installing the appliance, make the electrical connection complete with equipotential
earth connection (see Fig. 4).
After connecting to the electrical outlet, open the cover (7) (see Fig.1) and close the flap
(13) (see Fig. 1) at the base of the whole bean coffee container (2).
Remove the lid (3) from the container (2) and fill with whole bean coffee.
Bring the switch (4) to the "ON" position. The red led on the switch itself will come on.
Open the flap (13) and reclose the cover (7).
Place the portafilter on the fork (10) (see Fig. 7) and push forward till in contact with
the microswitch (6) to allow the flow of ground coffee from the spout (11) (see Fig.8).
Removing the portafilter will not stop the flow of ground coffee since it is determined by
the time previously programmed.
Position the portafilter containing the dose of ground coffee in the fork (10) and lower the
lever (8) till you hear a click (see Fig. 9). In raising the lever make sure that it re-arms
itself (it must make another click) for the next press.
MYTHOS 19