Kerf Insert Adjustment; Transporting And Mounting; Preparing To Lift The Saw - Bosch CM12 Consignes De Fonctionnement/Sécurité

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 16

Kerf Insert Adjustment

The kerf inserts should be adjusted close to the
blade, but without touching the blade, to avoid tear-
out on the bottom of the workpiece.
1. Hold the saw head assembly down and push in
the head assembly lock pin (item 36 – page 8)
to keep the saw in the DOWN position.
2. Loosen the two kerf insert screws using a #2
Phillips screwdriver.
3. Adjust the kerf inserts as close to the blade
(teeth) as possible without touching the blade.
4. Tighten the kerf screws.
NOTE: At extreme bevel angles, the saw blade
may slightly cut into kerf insert.
To avoid injury, follow all state-
WARNING
ments identified below by the
BUllET (•) symbol.
• Never lift this saw by grasping the base exten-
sions when they are in the extended position.
• Unplug electric cord and wind up. Use the hook
and loop strap to hold the wrapped cord together.
• Never lift the saw by gripping any of the mech-
anism parts. The saw may move and cause se-
vere injuries to your fingers or hands.
• To avoid back injury, hold the tool close to your
body when lifting. Bend your knees so you can
lift with your legs, not your back.
• Never lift tool by holding switch handle. This
may cause serious damage to the tool.
• Never lift the miter saw by the power cord. At-
tempting to lift or carry the tool by the power cord
*Always follow manufacturer instructions*
Adjustments

Transporting and Mounting

*AAA Rent-All 225-291-1356*
FIG. 17
will damage the insulation and the wire connec-
tions, resulting in electric shock or fire.
• place the saw on a firm, level surface where
there is plenty of room for handling and prop-
erly supporting the workpiece.
ONlY lift this saw by the cast-in carry handles
at each side of the bottom of the base, top carry
handle, or rear carry handle.

preparing To lift The Saw

Set bevel angle at 0° and lock in place using the
bevel lock lever.
Rotate the table to either 45 or 0° and lock into place
using the miter lock knob.
Lock the saw head in the DOWN position with the
head lock pin.
Check that each base table extension is in the
closed position and locked in place (See Figure 18).
-16-
Kerf Insert
Screws