Checking Left 45° Bevel Adjustment - Bosch CM12 Consignes De Fonctionnement/Sécurité

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 14
A. Rotate the bevel stop bolt clockwise to adjust
the head to the left.
B. Rotate the bevel stop bolt counter-clockwise
to adjust the head to the right.
5. Follow the procedure in "Checking 0° Bevel Ad-
justment" to check your modifications. If further ad-
justment is required, repeat the steps above.
6. Once satisfactory, lock the bevel lock at 0° to
prevent movement.
7. Finger tighten the lock nut in place. Once se-
cured, tighten the lock nut with wrench.
Checking left 45° Bevel Adjustment
1. Lower head assembly and engage head as-
sembly lock pin.
2. Rotate table to 0° miter position and lock.
3. Slide the fence completely to the left to avoid
hitting it with the saw head.
4. Pull forward bevel lock lever to unlock bevel.
5. Check range of bevel range selector stop. It
should be at 45°. (See Figure 11)
FIG. 11
6. Tilt the saw assembly to the left until you feel it
stop. This is where the saw is currently set for
45° bevel cut.
7. Use a combination square to check blade
squareness to the table. Place the combination
square on the table and press its 45° surface
against the blade. If the blade does not contact
the full length of the square, follow the calibra-
tion procedure. (See Figure 12)
*Always follow manufacturer instructions*
Adjustments
lock Nut
Bevel Stop Bolt
*AAA Rent-All 225-291-1356*
Calibrating Blade at left 45° Bevel
Note: Use a 1/2" (13mm) wrench for adjustment.
Note: Calibrating the bevel setting automatically
calibrates the 33.9° and 47° left stops.
1. Lower head assembly and engage head as-
sembly lock pin.
2. Slide the fence completely to the left to avoid
hitting it with the saw head.
3. Check bevel range selector stop located on the
left side of the bevel post on the table. It should
be at 45°.
4. Pull the bevel lock forward to unlock the head
assembly.
5. Locate the bevel stop bolt along the left side of
the bevel post. This bolt features a lock nut.
(See Figure 11)
4. Loosen the bevel stop bolt a quarter turn and
then loosen the lock nut. When this is complete
you will be able to adjust the bevel stop bolt by
hand.
A. Rotate the bevel stop bolt clockwise to
adjust the head to the right.
B. Rotate the bevel stop bolt counter-clock-
wise to adjust the head to the left.
5. Follow the procedure in "Checking left 45° Bevel
Adjustment" to check your modifications. If fur-
ther adjustment is required, repeat the steps
above.
6. Once satisfactory, lock the bevel lock at 45° to
prevent movement.
7. Finger tighten the lock nut in place. Once se-
cured, tighten with wrench.
-14-
FIG. 12