Bosch CM12 Consignes De Fonctionnement/Sécurité page 28

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 28
• Notes: Position workpiece with its back flat on the
saw table.
• Always place top edge of molding against fence
(Decorative edge is at the bottom of crown molding.)
Crown molding's "spring angle" is the angle between
the back of the molding and the bottom flat surface
that fits against the wall.
1. For 90º corner, set the bevel and miter angles using
Charts below. Tighten the miter lock knob and the
bevel lock lever (See Figure 40).
2. Position molding on saw table. Clamp workpiece
in place using the quick clamp.
Use clamping position that does
WARNING
not interfere with operation. Be-
fore switching on, lower head assembly to make
sure clamp clears guard and head assembly.
3. Follow procedures for chop cut (see page 23).
4. Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
NOTE: AlWAYS TAKE A TEST CUT USING SCRAp
TO CONfIRM CORRECT ANGlES.
*Always follow manufacturer instructions*
Saw Operations
Crown Molding laying flat on Table
*AAA Rent-All 225-291-1356*
Crown Molding
Crown Molding lying flat
Bevel Scale Settings
For 45° For 38°
Spring Angle
Spring Angle
-28-
FIG. 40
Bevel
Scale
Material
Clamp
Miter Scale
Miter Scale Settings
For 45° For 38°
Spring Angle
Spring Angle