Attaching Miter Lock Knob; Adjustments; Checking 0° Bevel Adjustment - Bosch CM12 Consignes De Fonctionnement/Sécurité

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 13

Attaching Miter lock Knob

Locate the miter gauge lock knob from among the
loose parts, and thread shaft on lock knob into hole
provided. (See Figure 8)
Disconnect plug from power
WARNING
source before performing any
assembly, adjustment or repair to avoid possible
injury.
NOTE: Your miter saw was completely adjusted at
the factory. However, during shipment, slight mis-
alignment may have occurred. Check the following
settings and adjust if necessary prior to using this
miter saw.
Checking 0° Bevel Adjustment
1. Lower head assembly and engage head assem-
bly lock pin.
2. Rotate table to 0° miter position and lock.
3. Pull forward bevel lock lever to unlock bevel.
4. Tilt the saw assembly to the left, then rotate saw
assembly to the right until you feel the stop in the
vertical position. This is where the saw is currently
set for 0° bevel cut.
5. Use a combination square to check blade
squareness to the table. Place the square on the
table and press it against the blade. If the blade
does not contact the full length of the square, fol-
low the calibration procedure. (See Figure 9)
Combination
Square
Table
*Always follow manufacturer instructions*

Adjustments

FIG. 9
Blade
*AAA Rent-All 225-291-1356*
Calibrating Blade at 0° Bevel (90° to the table)
Note: Use a 1/2" (13mm) wrench for adjustment.
Note: Calibrating the bevel setting automatically
calibrates the 33.9° left stop and -2° right stop.
1. Lower head assembly and engage head assem-
bly lock pin.
2. Pull the bevel lock forward to unlock the head
assembly.
3. Locate the bevel stop bolt below the bevel lock
handle on the right side of the bevel post. This bolt
features a lock nut. (See Figure 10)
FIG. 10
4. Loosen the bevel stop bolt a quarter turn and
then loosen the lock nut. When this is complete
you will be able to adjust the bevel stop bolt by
hand.
-13-
FIG. 8
Bevel lock
Handle
Bevel Scale
pointer
Bevel Scale
lock Nut
Bevel Stop Bolt
° Bevel Stop
-2
Right