Kerf Insert; Depth Stop Adjustment - Bosch 3915 Consignes De Fonctionnement/Sécurité

The kerf insert should be adjusted close to the blade,
but without touching the blade, to avoid tear-out on
the bottom of the workpiece.
1. Lower the head assembly and lock into position.
2. Loosen the six (6) kerf screws using the Phillips
screwdriver (Figure 13).
3. Adjust the kerf inserts as close to the blade
(teeth) as possible without touching the blade.
4. Tighten the kerf screws.
NOTE: At extreme bevel angles the saw blade may
slightly cut into kerf insert.
— The depth stop adjustment is a feature used
when cutting grooves (or dados) in the work-
piece. (See page 26 for cutting grooves.)
— When the diameter of the blade has been
reduced due to sharpening, it may be necessary
to adjust the depth stop. When a new blade is
installed, it is necessary to check the clearance
of the blade to the turn table structure.
Follow these instructions for adjusting the depth
stop.
1. Loosen the two (2) jam nuts on the end of the
depth stop bolt (Figure 14).
2. Loosen the knurled nut at the top of the arm
(Figure 14).
3. The saw blade is lowered by turning the depth
stop bolt counterclockwise and raised by turning
the bolt clockwise.
4. Lower the blade into the slot of the turn
table. Check blade clearance and maximum cut-
ting distance (distance from fence where blade
enters) to front of work table slot. Adjust if neces-
sary.
Do not start the slide compound
CAUTION
!
miter saw without checking for inter-
ference between the blade and the turn table struc-
ture. The blade could be ruined if it cuts into the table
structure.
All manuals and user guides at all-guides.com
Adjustments

Kerf Insert

Depth Stop Adjustment

16.
Kerf Screws
5 10
Kerf Screws
Figure 13. Kerf Insert
Depth Stop
Bolt
Figure 14. Depth Stop Adjustment
5. Tighten the knurled nut at the top of the
arm.
6. Tighten the two (2) jam nuts against the depth
stop base.
Kerf Inserts
Knurled Nut
Depth Stop Base
Jam Nuts
Depth Stop