Switch Activation - Bosch 3915 Consignes De Fonctionnement/Sécurité

Table des Matières

Les langues disponibles

Basic Saw Operations

Auxiliary Fence - Certain types of molding need a

fence face extension because of the size and position

of the workpiece. Holes are provided in the fence to

attach an auxiliary fence. The auxiliary fence is used

with the saw in the 0° bevel position only.

1. Place a piece of wood against the miter saw

fence (Figure 23). (Wood can have a maxi-

mum height of 3-1/4". Check that head

assembly does not interfere with auxiliary

fence.)

2. Mark the locations of the support holes on

the wood from the back side of the fence.

3. Drill and countersink the holes on the front of

the support board.

4. Attach the auxiliary fence using three (3) 1/4"

flat head machine screws. Make a full depth

cut to create the blade slot. Check for inter-

ference between the auxiliary fence and the

lower blade guard. Make adjustments as

necessary.

Check for interference from any

WARNING

components.

The safety switch is designed to prevent accidental

starts. To operate safety switch, press the switch

"Lock-OFF" button with your thumb (or index finger for

left hand) to disengage the lock, then pull the power

switch trigger and release the switch "Lock-OFF" but-

ton (Figure 24). When the power switch trigger is

released, the switch "Lock-OFF" button will engage

the safety switch automatically, and the trigger will no

longer operate.

NOTE: Switch can accommodate a padlock with a

long shackle of up to 1/4" in diameter (not provided

with slide compound miter saw) to prevent unautho-

rized use.

All manuals and user guides at all-guides.com