Blade Square To Fence; Miter Scale Indicator Adjustment - Bosch 3915 Consignes De Fonctionnement/Sécurité

1. Make sure head assembly is pulled forward near
the center of the table and slide rail lock knob is
tightened.
2. Lower the head assembly, pull the lock pin out
and rotate it 90°, rotate to lock in the
lower position. Make sure table is in 0° detent
and tighten miter lock knob. Place a combination
square against the fence and next to the blade as
illustrated. Locate the square properly so it does
not contact the tooth of saw blade. The saw
blade should contact the full length of the square
(Figure 10).
3. If blade does not contact the square, follow the
fence alignment procedure.
Fence
Combination Square
Figure 10. Blade Square to Fence
Miter Scale
Indicator Adjustment
1. Rotate table to 0° position and lock in place.
2. Raise the head assembly to the full-up position.
3. Loosen the Phillips screw that holds the indica-
tor in place (Figure 12).
4. Position the indicator to align with the 0° miter
mark. Tighten the screw.
All manuals and user guides at all-guides.com
Adjustments

Blade Square to Fence

Blade
15.
Fence Alignment
a. The head assembly should remain in lowered
position.
b. Use hex wrench (supplied) and loosen three
(3) hex cap screws behind fence (Figure 11).
c. Adjust fence until blade and the fence has full
contact with the square.
d. Tighten hex cap screws.
Fence
Hex Cap
Screws
Figure 11. Fence Adjustment
Indicator
Adjustment
Screw
0° Mark
Miter Scale
Indicator
Figure 12. Miter Scale Adjustment
Hex Cap
Fence
Screw
Hex "L" Wrench