Assembly; Tools Needed For Assembly And Alignment; Unpacking And Checking Contents - Bosch 3915 Consignes De Fonctionnement/Sécurité

Tools Needed For Assembly And Alignment

Phillips Screwdriver
Combination Square
Should be no Gap or Overlap
when Square is Flipped Over in
Dotted Position
Disconnect plug from power source before performing any assembly, adjustment or repair to
WARNING
!
avoid possible injury.

Unpacking And Checking Contents

Before moving the saw: Lock the
WARNING
!
miter lock knob in 45° position.
Lock bevel lock handle. Pull the head assembly
completely toward you and tighten the slide rail lock
knob.
Lock head assembly in the down position.
Never carry the tool by the slide rails, this may
cause blade misalignment.
Never carry the tool by the cord or head assembly
power switch handle. Damage to insulation could
cause an electric shock. Damage to wire connections
could cause a fire.
Model 3915 Slide Compound Miter Saw is shipped
complete in one box.
1. Separate all parts from packing materials and
check each one with the "Table of Loose Parts" to
All manuals and user guides at all-guides.com

Assembly

Hex "L" Wrench
(supplied) 6mm
Combination Square Must be True
Draw Light
Line on Board
Along this Edge
10.
Straight Edge of
Board 3/4" Thick
This Edge Must be
Perfectly Straight
make sure all items are accounted for before dis-
carding any packing material.
2. Table of Loose Parts:
Quick Action Clamp - Used to clamp work-
pieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
Hex Wrench - Should be stored on the left rear
base.
Blade Wrench - Should be stored in the handle.
If any parts are missing, do not plug
WARNING
!
in power cord or turn the switch on
until the missing parts are obtained and are installed
correctly.
Blade Wrench
(supplied)