Specifications; Display Messages - Sony CDP-LSA1 Mode D'emploi

Additional Information

Specifications

Compact disc player
Laser
Inputs/Outputs (i.LINK S200)
i.LINK connector
General
Power requirements
Power consumption
Dimensions (approx.) (w/h/d)
Mass (approx.)
Supplied accessories
i.LINK connecting calbe (4 pins - 4 pins) (1)
Remote commander (remote) (1)
Design and specifications are subject to change without
notice.
GB
20
Semiconductor laser (λ = 800 nm)
Emission duration: continuous
4 pins - 4 pins (S200)
230 V AC, 50/60 Hz
22 W
430 × 70 × 315 mm
incl. projecting parts
4.6 kg

Display Messages

The following table explains the various messages that
appear in the display.
Message Error code(s)
CANNOT C78:11/C78:12
LINC
BUS FULL C78:15
LOOP C78:03
CONNECT
NEW —
CONNECT
Cause and/or remedy
The player cannot establish
a LINC with a component
because of an existing LINC
between the player and
another component. Cancel
the LINC between the
player and the other
component.
The signal bus within the
i.LINK configuration is full
and no more signals can be
output from the player.
Cancel the LINC between
the component and the
player.
The i.LINK connection is
looped. Check the
connection (see page 17).
An i.LINK component has
been connected to or
disconnected from the
i.LINK configuration. Wait
several seconds for the
indication to turn off.