Sony CDP-LSA1 Mode D'emploi page 5

Hookups
Connecting the player to a receiver
Connect the receiver to the i.LINK S200 connector with
the i.LINK connecting cable (supplied). Make sure all
connections are firm. If not, there will be no sound
from the speakers.
CDP-LSA1
i.LINK S200
v v ≈
:
ç Signal flow
Notes
• Do not connect the mains lead of any component until all
the connections have been completed.
• Do not allow any metal object to enter the i.LINK S200
connector as this may short-circuit the connector and
damage the components.
z
The other i.LINK S200 connector can be used to
connect other components
The following i.LINK components can be used with the
player:
• STR-LSA1 receiver
• MDS-LSA1 MD deck
Be sure to use the Sony i.LINK S200 connecting cable
(4 pins - 4 pins).
z
For general information about i.LINK
See "About i.LINK" on page 16.
Connecting the mains lead
Connect the mains lead to a mains.
Removing the protective bar
Remove the attached protective bar and retain it for
use when transporting the player at a later time.
DIS PLA Y
When you connect the mains lead to a mains, the disc
tray will close automatically after a while.
Where do I go next?
Now you're ready to use your player.
If you aren't familiar with how to play CDs, go to the section
"Playing a CD" on page 6.
Then, go to the following sections for other operations.
Receiver
i.LINK S200
v v
§
§
Getting Started
Getting Started
Attaching the protective bar
When transporting the player, be sure to attach the
protective bar (which you removed at the time you
unpacked the player) onto the disc tray, and use
adhesive tape to secure the bar. If you fail to
attach the protective bar, the player may be
damaged during transport.
1
With the disc tray opened, disconnect the
mains lead.
2
Place the protective bar on the disc tray as
shown below.
Y
DIS PLA
3
Push the disc tray with your fingers to close it.
Y
DIS PLA
Slowly push both sides of the disc tray as
shown above.
4
Secure the protective bar with adhesive tape.
DIS PLA Y
x ·
§
§
§
5
GB