OFYR Classic Corten 100 Manuel page 3

Masquer les pouces Voir aussi pour Classic Corten 100:

Table des Matières

Les langues disponibles

SETUP OF COOKING UNITS

The exterior of the Octabin features an explanation regarding how to unpack your OFYR

that all cooking units must be set up exactly as explained in these setup instructions! We are not liable for any

damage resulting from incorrect setup attempts of OFYR

BASE & CONE

First, place the base on a fireproof surface. For our OFYR

the base with two people, due to its considerable weight. Then, place the cone in the base's hole levelly. If your surface

is not entirely level, you can use the base's adjustable feet to make sure that it is level. Please note that if the adjustable

feet are extended too far, the OFYR

10 mm If the level difference exceeds 10 mm, we recommend levelling the surface before setting up the OFYR

cooking unit. Once the OFYR

to the adjustable feet and/or the rivet nuts with which the adjustable feet are attached. We do not accept warranty

claims or liability for any damage resulting from shifting your OFYR

Classic Black has a coating and is thus more sensitive to damage during setup. We are not liable for any damage

or consequential damage resulting from the setup of your OFYR

wooden work surfaces on the right. These surfaces have nylon feet that block any heat conduction from the top of

the Island base. The base contains a second top, and there is a gap of a few millimetres between the base and the

top. At the front right, back, or side of the base, this gap can be used to insert the tool tray.

OFYR

MANUAL - COOKING UNITS

unit may become unstable. We recommend a maximum difference in level of

cooking unit has been set up, it must not be shifted. Shifting it could cause damage

Fig.3 - OFYR's unpacking procedure

cooking units.

Island models and OFYR

Concrete, we recommend placing

cooking unit. Please note that the OFYR

cooking unit. Our OFYR

cooking unit. Please note

Island models contain

Table des Matières