OFYR Classic Corten 100 Manuel page 10

3. Setup of cooking units
WILL MY OFYR COOKING UNIT SHOW SIGNS OF CORROSION UPON DELIVERY?
®
Yes, your OFYR cooking unit's corrosion process will already have started upon delivery. As the unit stands outside,
®
the corrosion process will continue.
WHY DOES THE COOKING PLATE FEEL STICKY?
The cooking plate was oiled before transport to protect it against corrosion forming.
DO I NEED TO PLACE A PLATE UNDERNEATH MY OFYR
ON FROM FIRE DAMAGE?
Water and ash may drain or drop down the hole in the OFYR
surfaces to be permanently stained. To protect your surface, you can place a stone underneath the OFYR
unit, place a fireproof bucket underneath, or place a steel plate in the base. The bottom of the base is not likely to
heat up enough during average use to damage your surface. In spite of the precautions mentioned above, however,
corrosive water may run down the OFYR
Island and Storage models, the ashes are instead collected on the top plate.
HOW DO I PREPARE MY OFYR
Use the method described in Chapter 3, 'Initial use'. Once the cooking plate has been prepped, your OFYR
unit will be ready for its first cooking session. The food will stick to the cooking plate a little more at the beginning
than after 2-3 uses. Similar to an old-fashioned cast-iron frying pan, a natural non-stick coating will develop over time,
making for extremely enjoyable cooking.
CAN OFYR PRODUCTS BE MOVED WITH THEIR ADJUSTABLE FEET IN POSITION?
®
No, they cannot, because the weight of the OFYR
may damage the rivet nuts with which the adjustable feet are attached.
CAN THE ADJUSTABLE FEET ON OFYR
THE PRODUCTS CONSIDERABLY?
No, the adjustable feet are solely intended to ensure that OFYR
uneven surfaces. The feet should not be extended by more than 10 mm, because OFYR
become unstable and the feet may bend or break.
4. Usage
HOW DO I LIGHT MY OFYR
When you light your OFYR
that you let a low fire burn in it for 25 minutes first, to allow the cooking plate to settle properly.
HOW LONG WILL IT TAKE FOR THE OFYR
Once the OFYR cooking unit has been lit, it will take between 25 to 45 minutes, depending on the weather conditions
®
and the temperature outside, for the cooking plate to reach around 300˚C on the inner edge and around 200˚C
on the outer edge.
10
cooking unit and cause stains on light-toned surfaces. In the case of our
®
UNIT FOR ITS INITIAL USE?
®
cooking unit may cause the adjustable feet to bend or break and
®
PRODUCTS BE USED TO ADJUST THE HEIGHT LEVEL OF
®
COOKING UNIT?
®
cooking unit for the first time using the log cabin wood stacking method, it is important
®
TO BE READY FOR COOKING?
®
TO PROTECT THE SURFACE IT STANDS
®
cooking unit's cone. This may cause light-toned
®
cooking units can be made level when placed on
®
®
OFYR MANUAL - COOKING UNITS
®
cooking
®
cooking
®
cooking units may then