Universal Serial Bus (Usb); J2534 Pass-Thru Support - Bosch MTS 6516 VCI Mode D'emploi

en 22 | MTS 6516 VCI |
4.5 MTS 6516 VCI Connectors and Controls
A number of standard connectors and controls are
available on the MTS 6516 VCI to facilitate operation
and communication with vehicles and workshop net-
works. These connectors and controls are shown in the
following illustrations.
2
3
Item Description
1 LED Indicators
2 USB Wireless Adapter
3 SD Card Slot
4 USB Port
5 Recovery Button
6 DLC Connector
|
1699200075 B 2017-06-20
1
4
5
6
4.6

Universal Serial Bus (USB)

The MTS 6516 VCI has a fixed USB configuration which
cannot be changed. This ensures that the MTS 6516 VCI
can always be connected to a single PC running the
VCI Manager software so you can configure LAN or
WLAN settings required by your local network. In ad-
dition, it is important to note that a USB connection is
required to configure and update the firmware on the
MTS 6516 VCI.
4.7 Wireless Local Area Network (WLAN)
The 802.11g WLAN connection on the MTS 6516 VCI
is set up and configured while the device is connected
over USB to a PC running the VCI Manager software.
4.8 VCI Manager Software
The VCI Manager software is a host computer applica-
tion which runs on the Microsoft Windows operating
system to configure and update VCIs. The VCI Manager
software is also used to set the J2534 identity VCIs.
The VCI Manager software allows the configuration of
VCI-to-host PC communications and facilitates VCI firm-
ware updates.
4.9

J2534 Pass-Thru Support

The MTS 6516 VCI works with an OEM supplied J2534
PC computer application (PC program) for testing spe-
cific vehicles and systems.
The MTS 6516 VCI supports pass-thru programming
of the flash calibration files that are stored in a vehic-
le onboard controller (e.g., PCM, ABS, VTD). Refer to
specific operating instructions provided by the OEM
supplied J2534 PC application.
4.10 Additional MTS 6516 VCI Features
4.10.1 Data Link Connector and Cable
Communication between the MTS 6516 VCI and the
vehicle's electronic systems is through the 16-pin to
26-pin Data Link Connector (DLC) cable that is connec-
ted to the bottom center of the MTS 6516 VCI. A 9-pin
Deutsche cable is also available.
4.10.2 Power Source
The MTS 6516 VCI is intended to be powered from the
vehicle battery via the DLC Cable. The VCI may also be
powered over USB using your PC or by using the optio-
nal AC/DC 12-volt power supply with an extension cord
or when located near a suitable wall socket. The VCI
must be powered via the DLC cable or the optional AC/
DC 12-volt power supply when you are configuring the
VCI for wireless communication.
Robert Bosch GmbH