To Stop The Engine; Operating The Blower - Ryobi RBL42BP Manuel D'utilisation

■ Pull the starter grip and rope until the engine runs.

TO STOP THE ENGINE

Press and hold the ignition switch in "O" position until the
engine stops.

OPERATING THE BLOWER

See Fig. 5.
■ Slip arm through harness strap and onto shoulder,
then repeat for the other shoulder. Adjust the straps
to a comfortable position. Refer to Adjusting Harness
Straps earlier in this manual. Remove the product for
starting.
■ Start the blower. Refer to Starting and Stopping earlier
in this manual.
■ Put on the blower again. The product should be
operated on the operator's right side as shown.
■ To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
■ Operate power equipment at reasonable hours only —
not early in the morning or late at night when people
might be disturbed. Comply with the times listed in
local ordinances.
■ To reduce sound levels, limit the number of pieces of
equipment used at any one time.
English (Original instructions)
■ Operate blower at the lowest possible throttle speed
■ Check your equipment before operation, especially
■ Use rakes and brooms to loosen debris before
■ Conserve water by using power blowers instead
■ Watch out for children, pets, open windows, or freshly
■ Use the blower nozzle extension, so the air stream can
■ Clean up after using blowers or other equipment.
■ Dispose of debris properly.
Do not place blower on top of or near loose debris.
Debris may be sucked into blower intake vent resulting
in possible damage to the product.
21
to do the job.
the muffler, air intakes, and air filters.
blowing. In dusty conditions, slightly dampen surfaces
when water is available.
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
washed cars, and blow debris safely away.
work close to the ground.
CAUTION