Residual Risks; Blower Safety Warnings - Ryobi RBL42BP Manuel D'utilisation

■ Stop the engine and allow it to cool down before
refuelling, storing, or transporting the product.
■ For refuelling and fuel mixing, choose a well-ventilated
area away from sources of ignition (sparks, flames
etc.), and flammable materials.
■ Do not smoke when mixing fuel or filling the fuel tank.
■ Mix and store fuel in a container approved for fuel.
■ Keep an appropriate type of fire extinguisher nearby
for dealing with fuel fires.
■ Remember to securely refit the fuel tank filler cap
before starting the engine and check for fuel leaks
■ Wipe up any fuel spillage. Move 9 m away from the
refuelling site before starting the engine.
■ To reduce the risk of injury associated with contacting
rotating parts, always stop the engine, remove the
spark plug wire, and make sure all moving parts have
come to a stop before:
● cleaning or clearing a blockage
● leaving the product unattended
● installing or removing attachments
● checking, maintaining, or working on the product
WARNING
Your blower may be supplied with a harness. Carefully
adjust the harness to comfortably help to support the
weight of the product and hang at your back with the
bower tube at your right-hand side.
WARNING
Identify the quick release mechanism and practice
using it before you start using the product. Its correct
use may prevent serious injury in the case of an
emergency. Never wear additional clothing over
the harness or otherwise restrict access to the quick
release mechanism.

BLOWER SAFETY WARNINGS

■ Wear a face filter mask in dusty conditions to reduce
the risk of injury associated with the inhalation of dust.
■ Do not point the blower nozzle in the direction of
people or pets.
■ Never place objects inside the blower tubes.
■ Do not operate the product near open windows.
■ Slightly dampen surfaces in dusty conditions.
■ Use the full blower nozzle extension so the air stream
can work close to the ground.
English (Original instructions)
■ Do not place blower on top of or near loose debris.

RESIDUAL RISKS

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and
the operator should pay special attention to avoid the
following:
■ Injury caused by vibration. Always use the right tool for
■ Hearing damage caused by exposure to noise. Wear
■ Injury from flying objects from the blow tube airflow.
RISK REDUCTION
It has been reported that vibrations from handheld tools
may contribute to a condition called Raynaud's Syndrome
in certain individuals. Symptoms may include tingling,
numbness, and blanching of the fi ngers, usually apparent
upon exposure to cold. Hereditary factors, exposure to
cold and dampness, diet, smoking, and work practices
are all thought to contribute to the development of these
symptoms. There are measures that can be taken by the
operator to possibly reduce the effects of vibration:
■ Keep your body warm in cold weather. When operating
■ After each period of operation, exercise to increase
■ Take frequent work breaks. Limit the amount of
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged
periods, ensure you take regular breaks.
16
Debris may be sucked into intake vent, resulting in
possible damage to the product.
the job. Use designated handles and restrict working
time and exposure.
ear protection and limit exposure.
the product wear gloves to keep the hands and wrists
warm. It is reported that cold weather is a major factor
contributing to Raynaud's Syndrome.
blood circulation.
exposure per day.
WARNING