Servicing The Tool; Maintenance Frequency; Cleaning - DeWalt Stanley PB2500 Traduction Des Instructions Originales

Emptying the mandrel collector (W) (fig. 6)
The mandrel collector is used to collect the waste mandrels. The mandrel collector must be emptied depend-
ing on the size of the blind rivets used.
Nom. Rivet Dia.
2.4 mm [3/32"]
3.2 mm [1/8"]
4.0 mm [5/32"]
4.8 mm [3/16"]
6.4 mm [1/4"]
•
Tilt the tool back to allow all waste mandrels to fall into the mandrel collector.
•
Open the mandrel collector (W) by sliding the Collector Lock (D) towards the nose housing nut (C) and
raise the cover (E).
•
Empty the waste mandrels into an appropriate recycling container or waste bin
•
To close the mandrel collector (W), lower the cover (E) until the Collector Lock (D) clicks into place.

6. SERVICING THE TOOL

6.1

MAINTENANCE FREQUENCY

Item
General Tool Inspection
Clean & lubricate Nose Equipment
Clean & grease Ball Screw and Thrust Bearing
*Recommend contacting authorized service centre
6.2

CLEANING

ALWAYS wear approved eye protection at all times when cleaning equipment
Tool Exterior
Keep the brushless motor exhaust vent openings (H) free from dust and dirt. If necessary, use a soft, moist
cloth to remove dust and dirt from the exhaust vents. Blow dirt and dust out of the main power tool housing
with dry air as often as dirt is seen collecting in and around the exhaust vents (H).
WARNING: Wear approved eye protection and approved dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool.
These chemicals may weaken the materials used in these parts. Use a cloth dampened only with water
and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.
Cleaning the Nose Equipment (fig. 4 & 5)
•
Loosen the nose housing nut (C). Remove the nose housing (B).
•
Press the front clutch (U) and loosen the jaw guide (P). Release the front clutch (U).
•
Remove the jaws (Q) and the jaw pusher (R).
•
Remove the spring (S)
•
Clean the inside of the nose housing (B) using a dry cloth.
•
Clean the jaws (Q) and the jaw pusher (R) using a dry cloth. If necessary, replace the jaws (Q) and the jaw
pusher (R).
•
Clean the pulling head (T) using a dry cloth.
Approx. Capacity (PB2500 Smart)
Not applicable
Frequency
Daily
5,000 rivets
50,000 rivets*
E N G L I S H
600
360
200
150
17