Front Cover - Hitachi RAF-25NH4 Données Techniques

3. FRONT COVER

Remove the four securing screws of the front cover, and then pull the front cover towards you.
When attaching the front cover, insert the front cover tabs into these openings.
Securing screw
TT CHING
When attaching the front cover, fit the three tabs on the top of the front cover so that they enter the openings on the top frame
(insert from a slightly raised position). Be sure that the tabs are inserted correctly.
4. INDICATION P.W.B.
(1) Use a screwdriver or other such tool to push up the tabs of the section A from below, and remove.
(2) As shown in the following diagram, slide the L-shaped tab on the indication P.W.B. to the right so that it enters the hole in
the top frame. You can then remove the indication P.W.B. by pulling upwards.
Top frame
Securing tabs
5. TOP FRAME
(1) Remove the front panel, and then remove the front cover.
(2) Remove the indication P.W.B..
(3) Remove the cord from the stepping motor of the air deflecfor.
(4) Remove the three securing screws of the top frame, and pull the frame towards you.
PUSH
Section A
Slide to the right and lift upwards to remove.
246
Cabinet
Front cover
Indication P.W.B.