Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Top frame
Securing screw
TT CHING
(1) When attaching the top frame, align the left and right of the top frame with the inside of the guides
on the cabinet, and then push the top frame straight to the back.
Note: Check to see that there is no space between the top frame and the cabinet.
(2) Fasten the three securing screws, and then check to see that the top frame does not slip to the side.
6. DISCHARGE FRAME
(1) Remove the three securing screws of the discharge frame.
(2) Remove the screw on the rat prevention cover.
(3) Lower the rear side of the discharge frame, remove the tab on the interfit section, and then pull out the discharge frame
towards you.
Discharge frame tab
Discharge frame
Securing screw
TT CHING
(1) Align the tabs to the left and the right of the discharge frame with the holes in the cabinet, lift up the discharge frame while
pushing it to the rear, and keep pushing until it clicks into place.
Note: After installing, check to see that the cabinet and the discharge frame are correctly fitted together, as shown in section B.
Interfit hole
Cabinet
248
Stepping motor
Cabinet
Internal electrical parts
Discharge frame tab
Rat prevention cover
Publicité
Table des Matières
