Hitachi RAF-25NH4 Données Techniques page 225

ISASSEMBLY AN REASSEMBLY
MODEL RAF-25NH4, RAF-50NH4
1. AIR FILTER
Clean the air filter, as it removes dust inside the room.
Be sure to clean the filter once every two weeks so as not to consume electricity unnecessarily.
PROCE URE
1
Open the front panel.
¥ To open the front panel, use the remote controller to stop unit
operation. Then press the two Ò
left and right corners of the front panel.
¥ Grasp the left and right sides of the front panel and open it toward you.
2
Remove the filters.
3
Remove dust of the filters using a vacuum cleaner.
¥ After using neutral detergent, wash with clean water and dry in
shade.
4
Attach the filters.
¥ Attaching the filters which are placed the surface written ÒFRONTÓ
up.
5
Close the front panel.
¥ To close the front panel, press the two Ò
at the top left and right corners of the front panel.
¥ Press the upper center part of the front panel to close properly.
2. FRONT PANEL
¥ Be sure to use both hands to grasp the front panel when removing it or attaching it.
¥ The front panel may be installed up or down to suit user preference.
Removing
Press the hook found at the tip of the resin band
1
installed inside the front panelÕs right section to
remove the resin band.
Attaching
Attach three front panel bearings to the axis of
1
the front cover.
Ó sections below PUSH at the top
Ó sections below PUSH
Front cover
Resin band
Hook
Front panel
244
Pull the front panel down toward you and once
2
fully open, pull it to remove.
Insert the tip of the resin band into the hole of the
2
protrusion inside the right section of the front
panel.
Resin band