EdilKamin INPELLET 54 Installation, Usage Et Maintenance page 34

POSSIBLE TROUBLESHOOTING
9) Remote control inefficient:
• go closer to insert
• remove the antenna
• replace with alkaline batteries (3 mini AAA type)
10) Output air not hot:
• clean the hearth exchanger.
11) Does not ignite:
• clean combustion chamber.
12) "Battery check":
The INPELLET 54 does not stop but the error appears on the display.
The buffer battery of the control board needs changing.
NOTA 1
All signals/warnings remain shown until you intervene on the remote control, by pressing the button
Do not use the insert before having eliminated the problem.
It is important to tell the Dealer exactly what the panel signals.
NOTA 2
After 1000 kg of pellets consumed, the display flashes the wording 'Mainten.'.
The insert works, but you must call the Dealer out to perform extraordinary maintenance.
NOTA 3
If due to the quality of pellets or particularly critical installation, the insert becomes clogged earlier, the message
"CALL SERVICE" will appear. Proceed as per "Mainten." instructions.
N.B.:
The combustion chambers and smoke ducts connected to the solid fuel appliances must be clea-
ned once a year (check if your country has specific legislation covering this).
Failure to regularly check and clean increases the likelihood of a fire in the chimney pot.
In that case, proceed as follows:
do not shutdown with water;
empty the pellet tank;
contact specialised staff before restarting the machine.
34
.