Power Regulation; Turning Off - EdilKamin INPELLET 54 Installation, Usage Et Maintenance

Before igniting.
1st ignition: contact your local Dealer, who will calibrate the insert based on and in compliance with installation condi-
tions.
Failure to have an authorised Edilkamin DEALER perform start-up will void the guarantee.
They will calibrate the insert according to the type of pellets available and the conditions of use.
There may be a slight smell of paint the first few times it is ignited. This will disappear quickly.
Before igniting, check:
• that installation is correct
• electricity supply
• that the door closes correctly
• that the combustion chamber is clean
• stand-by indicated on the remote control display: hours (fixed display), ambient temperature and the reserve (or kg of
pellets in the tank) will flash alternately on the display.
Filling the cochlea.
The first time you use the product, or should the tank be completely emptied of pellets, to fill the coclea press both keys
"+" and "–" on the remote control at the same time, holding for a few seconds. As you release the keys, the display
should show the wording "LOAD".
This should be carried out before ignition if the insert has stopped due to having run out of pellets, at the end of operation
to empty the combustion pot before turning.
It is quite normal for some pellets to remain, that the cochlea cannot suction.
Automatic igniting.
With the insert on stand-by, press and hold the key
ignition procedure, showing the wording "START". At the same time, a countdown in seconds begins (from 1020 to 0).
Ignition is not at a preset time, however: its duration is automatically shortened if the board reports that certain tests have
been passed. The flame appears after about 5 minutes.
Manual igniting.
Temperatures of below 3°C will not allow the electrical resistance to heat sufficiently. In this case, or should the
resistance be temporarily out of action, Diavolina® type fire-starters can be used.
Insert a piece of lit Diavolina® into the combustion chamber, close the door and press

POWER REGULATION

Remote control manual operation
•
With the insert working, press the key "M" on the remote control once. The display will show the word "POWER P".
(specifying the power at which the insert is working). Press the keys "+" or "–" to increase or decrease the insert's
working power (from "POWER P1" to "POWER P5").
Remote control automatic operation
•
Press key "A" to switch to automatic operation, adjusting the temperature desired for the room (use the "+" and "–" keys
to set the temperature from 5°C to 35°C, and the insert will regulate working power required to reach the temperature
set.
If a temperature below that of the room is set, the insert will stay on "POWER P1".

Turning off

With the insert running, press and hold the key
begin, showing a countdown on the display from 9 to 0 (for a total of 10 minutes).
The turn-off phase involves:
• Interruption of pellet supply
• Maximum ventilation.
• Smoke expulsion motor.
Never pull the plug out whilst the device is still in the process of turning off.
INSTRUCTIONS FOR USE
, on the remote control for 2 seconds. This will start-up the
from the remote control for 2 seconds. The turn-off procedure will
29
the remote control.