Principle Of Operation - EdilKamin INPELLET 54 Installation, Usage Et Maintenance

PRINCIPLE OF OPERATION

INPELLET 54 is an insert that uses pellets as fuel.
Combustion is electronically managed.
The fuel (pellets) is taken from the storage tank (A). A
cochlea (B) is enabled by a gear motor (C), which takes the
fuel to the combustion chamber (D).
The pellets are ignited by hot air produced by an electrical
resistance (E) and suctioned into the combustion chamber by
means of a centrifugal fan (F).
The smoke produced by combustion is extracted from the
hearth by means of this centrifugal fan (F) and expelled from
the mouth (F) located in the upper area of the insert (L).
Fans (G) transits air into the hollow space behind the hearth,
where it is heated before being released in the environment
opposite the slits (H) around the fireplace door.
The fuel tank (A) is situated to the rear of the insert.
The tank is filled through a sliding drawer (I) located in the
front part above the hearth.
The hearth has been constructed with a steel perimeter
structure, covered with lower panels in cast iron, closed to
the front by two overlaying doors.
- an external ceramic glass door
(to open use the specific thermal glove).
- an internal ceramic glass shutter in contact with the flames
(to open use the specific cold handle supplied).
Fuel quantity, smoke extraction and combustion air supply
are all regulated by the electronic board, guaranteeing high
performance combustion.
All operations for operation management can be controlled
by the remote control supplied.
In case of breakage or loss of the radio control, power on/off
and setting of the operating power can be made by an emer-
gency button inside the insert (see page 31).
NOTE regarding the fuel.
The INPELLET 54 pellet stove is designed and programmed to burn wood pellets with 6 mm diameter.
Pellets are a type of fuel made from compacted sawdust, compressed under high pressure with no adhesive or foreign
materials. They are small in size, approximately 6 mm in diameter and have a cylindrical shape. They are sold in bags
of 15 kg. For the stove to function properly, you MUST NOT burn anything else in it. Using other materials (inclu-
ding wood) will render the warranty null and void. Such use is detected by laboratory analyses.
EdilKamin has designed, tested and programmed their stoves to guarantee the best performance when pellets with
the following characteristics are used:
- diameter: 6 millimetres
- maximum length: 40 mm
- maximum moisture content: 8 %
- calorific value: at least 4300 kcal/kg
If pellets with different characteristics are used, the stove must be recalibrated – a similar procedure to that carried
out by the Dealer when the stove is ignited the first time.
Using unsuitable pellets may:
decrease efficiency; cause malfunctions; stop the stove from functioning due to clogging, dirt on the glass, unburnt
fuel, etc.
A simple, visual analysis of the pellets may be carried out.
Good quality: smooth, uniform length, not very dusty.
Poor quality: with longitudinal and transverse cracks, very dusty, various lengths and mixed with foreign matter.
I
H
D
E
20
L
A
B
G
C
F