Lubrication - EMAK OM106J Manuel D'utilisation

6.3.16 MAINTAINING THE HYDROSTATIC TRANSMISSION
Machines AJ102, AJ110 and AG122:
To ensure reliable operation of the transmission, you must maintain the proper oil level. The transmission
filling ports are accessible after removal of the machine's removal tube (
values are shown in the following chart.
Transmission type
TUFF-TORQ K46
TUFF-TORQ K62
TUFF-TORQ K664, KXH 10
Machines AJ102 4x4:
To ensure reliable operation of the transmission, you must maintain the proper oil level. The transmission
filling port is under the seat of the mower (
chart.
Transmission type
TUFF-TORQ K 664
KANZAKI KXH 10 N
If there are problems with the transmission, get immediate help from an authorized service
centre to prevent serious damage.
6.3.17 OVERVIEW OF BOLT TORQUE
Mowing mechanism:
Central blade bolt
M12 nuts for the mowing mechanism drive pulleys
10x25 KL 100 RIPP bolt for the shoulder of the tensioning pulley of the mowing
mechanism drive belt
Steering:
M8x30 bolt to the steering section
M12 bolt to the steering section
Engine:
Bolt to the electromagnetic connector
Bracket screw for the drive belt tension pulley
Self-locking nuts must be replaced with new ones during removal and reinstallation.

6.4 LUBRICATION

Lubricate the machine according to the following schedule.
The bearings of the tensioning pulleys, guide pulleys and mowing mechanism are self-lubricating.
Before storing the machine for an extended time, thoroughly lubricate all areas shown in the schedule.
But particularly the half-axles of the front and rear axles (it is necessary to disassemble the rear
wheels).
Oil type
SAE 10W-30, API CD
SAE 10W-30, API CD
SAE 5W-50, API CD
3.4.5). The prescribed values are shown in the following
Oil type
SAE 5W-50, API SG
synthetic oil
SAE 5W-50, API SG
synthetic oil
56
Oil level
at least half the height of the distribution reservoir
lines 5-7 on the distribution reservoir
Between the turns on the filling screw
Oil level
according to the level marks in the expansion
tank ( 3.4.5).
according to the level marks in the expansion
tank ( 3.4.5).
6.3.10). The prescribed
Torque
30 ± 3 Nm
45 - 55 Nm
55 - 65 Nm
15 - 25 Nm
35 - 45 Nm
60 - 70 Nm
25 - 35 Nm