Filling The Fuel Tank - EMAK OM106J Manuel D'utilisation

3.4.3 FILLING THE FUEL TANK

For safety reasons, the mower is transported without fuel, and it is necessary to fill the tank before
starting up for the first time. Depending on the machine's design, the fuel tank is located either under
the front bonnet or inside the left fender, and holds 7,5 l (types with container under the hood) or
13 (15) l (types with contanier in the mudguard) of fuel.
- Use only fuel of the octane rating designated in the engine manual. Defects caused by
improper fuel are not covered by the warranty!
- Fill the tank only when the engine is switched off and is cool. Fill the tank in a well-ventilated
area.
- When handling fuel, do not eat, smoke or use an open flame.
- For filling the tank, use a funnel intended for use with fuel.
- Make sure not to spill any fuel when filling the tank. Spilled fuel is highly flammable. If any
fuel spills, wipe it up until dry.
- Store fuel out of the reach of children.
Filling process:
Remove the fuel tank cap. Open it slowly, because the tank may contain

pressurized petrol fumes.
Insert the funnel into the filling port and pour in fuel from a canister.

After filling the tank, always wipe dry the cap and the area around it. It is

appropriate to check the fuel level through the lines.
We also recommend cleaning the tank itself regularly, because any
contaminants in the fuel can cause engine breakdown.
3.4.4 CHECKING TYRE PRESSURE
Before using the machine, check the air pressure in the tyres.
The air pressure in the front and rear tyres must be within the range
of 80 -140 kPa. The difference between the individual tyres can be
± 10 KPa.
Do not exceed the maximum pressure marked on the tyres that are being used.
3.4.5 CHECKING THE OIL IN THE HYDRAULIC CIRCUIT (only on the AJ102 4x4
machine)
Your machine is delivered with fully operational and fully deaerated hydraulic system and with an
equalising container filled with the correct amount of oil. The oil level may drop down during transport.
On the AJ102 4x4 machine the expansion tank is located under the seat
the expansion tank is located in the area of the transmission (
Check to see that the oil level is between the two measurement marks on the dipstick of the closing

stopper. If necessary, add the required amount of the specified oil.
When you finish, clean the lid and the intake surrounding with a cloth. Clean the entire tank as well,
because dirt in the oil shortens the oil filter life and may cause breakdowns.
3.4.6 DEAERATING THE HYDRAULIC CIRCUIT (only on the AJ102 4x4x machine)
Complete deaeration of the hydraulic circuit is achieved during the first hours the machine is running.
We recommend breaking the machine in gently for 1 – 2 hours. If during the initial break-in phase the
6.3.16).
35
3.4.5). On other machines