Control Layout; Description And Function Of Controls; Standard Controls - EMAK OM106J Manuel D'utilisation

hydraulic drive's sound changes, the front axle may be aerated. Deaerate by loosening the caps on the
left and right sides of the axle (
again.
3.4.7 CHECKING THE TIGHTNESS OF THE HYDRAULIC CIRCUIT
Visually inspect the hydraulic system for leakage. Pay special attention to locations where pipes and
armatures are connected. If you discover leakage contact the service centre.
4. CONTROLLNG THE MACHINE

4.1 CONTROL LAYOUT

(1) Accelerator lever
(2) Indicator for the brake pedal and parking brake
(3) Mowing function control switch when grass catcher is full
4.1a
(4) Switch for mowing mechanism
(5) Main switch
(6) Brake pedal
(7) Parking brake control
(8) Mulching lid lever
(9) Forward drive pedal
4.1b
(10) Backup pedal
(11) Mowing mechanism height adjustment lever

4.2 DESCRIPTION AND FUNCTION OF CONTROLS

4.2.1 STANDARD CONTROLS

(1) ACCELERATOR LEVER
Regulates engine RPM. Has the following three positions:
* Only on machines with engines BS15, BS17, KO15, TE17 and HO16
3.4.6). When the oil starts to flow out smoothly, tighten the caps
STARTER* To cold start the engine
MAX Maximum RPM
MIN Minimum RPM (idle)
36