Installation And Connections - ENAG CDS Série Manuel D'utilisation

ENAG
When they leave the factory the chargers are configured as follows:
Mains supply: 230 Vac
Battery: Lead/Antimony
Charging mode : Boost then automatic switch to Floating
Output voltage setting in Floating:
at 13.8 V ± 1% off load for 12 V models
at 27.4 V ± 1% off load for 24 V models
Cable entry is via cable glands except for 70 and 120 W models for which the battery
cables must be attached to terminals.
CDSDEB

Installation and Connections

Page 35