Commissioning; Selecting The Mains Supply Voltage; Selecting Battery Type - ENAG CDS Série Manuel D'utilisation

ENAG

3.5 Commissioning

This section lists the operations to be performed in order to commission the charger.
It is advisable to comply strictly with these instructions before switching on for the
first time.

3.5.1. Selecting the mains supply voltage

Selection of the input mains supply is made using the selector inside the metal
case, marked S1.
Precautions to be taken in using this selector are as follows:
The rating of circuit breakers placed on the supply side of the charger
must correspond with the latter's requirement.
There must be no ac voltage present when the selector is moved.
Position the voltage selector as a function of the type of alternating
mains supply used.
If this selector is incorrectly set irreversible damage to the charger may occur.

3.5.2. Selecting battery type

Drawings on pages 36 and 37 show the position of the selector as a function of
the type of battery used.
Precautions to be taken in using this selector are as follows:
You MUST check the compatibility of the selection and the type of
battery connected BEFORE you switch on.
CDSDEB
Page 54