Output Characteristics - ENAG CDS Série Manuel D'utilisation

ENAG

2.1.3 Output characteristics

2.1.3.1 Voltage
The output voltages shown in the table below are obtained at 10% of rated power on
outputs BAT 1 and BAT 2. For those models having a BAT D output, the voltage
level is reduced by about 0.4 V.
These values are set in the factory with an accuracy of ± 1% and can be adjusted by
turning the potentiometer POT U (use a suitable tool for turning the potentiometer
screw).
They depend on the type of battery and mode of operation selected.
Model
"Floating" Mode
SEEL005322
SEEL005326
SEEL005330
SEEL005336
SEEL005342
SEEL005348
SEEL005354
SEEL005324
SEEL005328
SEEL005332
SEEL005338
SEEL005344
SEEL005350
SEEL005356
SEEL005358
Lead/Antimony
Battery
13.8 Vdc
27,4 Vdc
CDSDEB
Lead/Antimony
Battery
"Boost" Mode
14.5 Vdc
28,8 Vdc
Lead/Calcium
Battery
"Floating" Mode
14.6 Vdc
29,0 Vdc
Page 42
Lead/Calcium
Battery
"Boost" Mode
15,4 Vdc
30,5 Vdc