On/Off Charger Output; Operation Setup ( Menu ) - ENAG CDS4 1H Manuel Utilisateur

5.3.3 ON/OFF charger output

Charger output can be switched ON and OFF by pressing ON/OFF charger output [3] onto main page.
In OFF mode, output current is 0A and therefore all battery voltages can be read.
AC Network voltage and frequency are available by pressing [4].
Press [3] to switch on the charger's output.
5
4
5.4
OPERATION SETUP
Setup  Operation
By pressing the parameter access button [2] onto main page and next the OPERATION button, you can control all
the main functions of the charger.
5
4
3
( )
MENU
3
1 : Battery voltages
2 : Access to parameters
1
3 : ON/OFF charger output
4 : AC network status
5 : Battery pack temperature (if probe
connected)
2
1 : Boost ON/OFF (see 4.4.1)
2 : ON/OFF charger output
1
3 : Home (return to main page)
4 : Input current limit (see 4.4.3)
5 : Current limit (see 4.4.4)
2
25