Installation; Wiring - See Appendix - ENAG CDS4 1H Manuel Utilisateur

4

INSTALLATION

This paragraph deals with installation of the equipment.
Installation and initial commissioning should be carried out by an electrician or professional installer in accordance
with the standards currently in force (for pleasure boats the applicable international standard is ISO10133).
a. Remove the front cover
b. Open the rubber grommet and pass the wire
through the opening
c. Secure the cable with the strain relief clamps
4.1 W –
IRING SEE APPENDIX
Make sure the battery charger is disconnected from AC mains and DC outlet is disconnected before
you plug the interface board.
The Remote Display shall be connected to the interface board via a 3 pole cable. The cable can be
shortened or you can use a cable up to 15m. The 3 pole cable provides the power supply of the
monitor as well as LIN-Bus communication.
When assembling the connectors to the wires, please use the pigtails and the 3 pole cable which is
part of the delivery.
Both LIN Terminals are connected in parallel, so only one has to be used. The second one is dedicated
for further applications.
22