Connecting To A Regulated Power Supply; Connecting To A Pc - Kenwood TH-D72A Mode D'emploi

CONNECTING TO A REGULATED POWER SUPPLY

To connect the transceiver to an appropriate regulated DC power supply, use an
optional PG-2W DC cable.
1 Confi rm that the power of both the transceiver and the DC power supply is
OFF.
2 Connect the optional PG-2W DC cable to the DC power supply; the red lead to
the positive (+) terminal, and the black lead to the negative (–) terminal.
3 Connect the barrel plug on the DC cable to the DC IN jack of the transceiver.
• While a DC power supply is connected with the DC IN jack, the transceiver
automatically initiates charging the PB-45L battery pack.
Note:
◆ If the DC power supply voltage is below 12.0 V DC, you may not be able to charge the PB-45L
battery pack.
◆ The supply voltage must be between 12.0 V and 16.0 V to prevent damaging the transceiver. If
the input voltage exceeds approximately 17.5 V, the transceiver automatically turns OFF.

CONNECTING TO A PC

The USB connector allows you to directly connect to a computer by using a
supplied USB cable.
• Download the virtual COM port driver from the URL listed below.
http://www.kenwood.com/i/products/info/amateur/software_download.html
PC
Depending on the usage condition of the USB apparatus, saved content may be lost. JVC
KENWOOD does not take responsibility for damages or lost content.
Fuses (3 A)
<Baud rate: 9600 bps for the built-in
TNC input / output and the internal GPS
output.>
Supplied USB cable
PC (USB) port
7