Frequency Direct Entry - Kenwood TH-D72A Mode D'emploi

FREQUENCY DIRECT ENTRY

If the desired operating frequency is far from the current frequency, using the
keypad is the quickest way to change the frequency.
1 Press [A/B] to select band A or B, then press [VFO] or [CALL].
2 Press [ENT].
• The Direct Frequency Entry display appears.
3 Press the numeric keys ([0] ~ [9]) to enter your desired frequency.
4 To set the entered frequency, press [ENT] or [VFO].
• Pressing [ENT] before entering all of the digits will set the remaining digits to 0.
• Pressing [VFO] before entering all of the digits will leave the remaining digits at their
previous values.
• Entering all digits for a frequency will automatically set the frequency without
pressing [ENT] or [VFO].
• In step 3, after entering 1 ~ 3 digits, pressing [MHz] will set the digits above the
MHz value.
For example, when the displayed current frequency is 432.250:
1 Press [ENT] ➡ – – – – – –
2 Press [4] ➡
3 Press [MHz] ➡ 4 3 4. – – –
4 – – – – –
19