Installing The Battery Pack; Installing Alkaline Batteries - Kenwood TH-D72A Mode D'emploi

INSTALLING THE BATTERY PACK

Note: Because the battery pack is provided uncharged, you must charge the battery pack before
using it with the transceiver. To charge the battery pack, refer to "CHARGING THE PB-45L
BATTERY PACK " {page 4}.
1 Unlock (open) the safety catch located at the bottom of the battery pack.
2 Match the guides of the battery pack with the corresponding grooves on the
upper rear of the transceiver, then fi rmly press the battery case to lock it in
place.
3 Flip the safety catch into place to prevent accidentally pressing the release
latch and removing the battery pack.
4 To remove the battery pack, lift the safety catch, then press the release latch to
unlock the battery pack. Lift the battery pack away from the transceiver.

INSTALLING ALKALINE BATTERIES

1 To open the optional BT-15 battery case lid, press the release lever on the top
of the battery case, then pull the cover up.
2 Insert (or remove) six AAA (LR03) Alkaline batteries.
• When removing the Alkaline batteries from the battery case, pull up on the batteries
from the positive (+) terminal.
2