Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch PCM 10 Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
OBJ_BUCH-573-001.book Page 37 Thursday, November 29, 2007 9:23 AM

Technical Data

Chop and Mitre Saw
Article number
Rated power input
Rated voltage
Frequency
No-load speed
Laser type
Laser class
Weight according to
EPTA-Procedure
01/2003
Protection class
Maximum workpiece dimensions, see page 43.
Starting cycles generate brief voltage drops. Interfer-
ence with other equipment/machines may occur in case
of unfavourable mains system conditions. Malfunctions
are not to be expected for system impedances below
0,363 ohm.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Saw blade mounting
hole
Bosch Power Tools

Noise/Vibration Information

Measured values determined according to
PCM 10
EN 61029.
3 603 L01 0..
Typically the A-weighted noise levels of the
product are: Sound pressure level 91 dB(A);
W
1500
Sound power level 104 dB(A). Uncertainty
V
230
K =3 dB.
Hz
50
Wear hearing protection!
rpm
4700
The hand-arm acceleration is typically below
2.5 m/s
650 nm, < 1mW
2

Declaration of Conformity

kg
13.8
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
/ II
standardization documents: EN 61029,
EN 60825-1 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until Dec.
28, 2009), 2006/42/EG (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
29.11.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
mm
254
mm
1.4–2.0
mm
30
2
.
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 J60 | (29/11/07)
English | 37

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières