Transport; Maintenance And Service; Maintenance And Cleaning; Accessories - Bosch PCM 10 Notice Originale

OBJ_BUCH-573-001.book Page 46 Thursday, November 29, 2007 9:23 AM
46 | English
Aligning the Angle Indicator (Horizontally)
(see figure X)
– Bring the machine into the transport posi-
tion.
– Turn the saw table 14 until it engages at 0°.
Checking:
The centre line of the angle indicator 53 must be
in line with the 0° mark of the scale 10.
Adjusting:
– Loosen the screw 61 using a commercial
Phillips screwdriver and align the centre line
of the angle indicator alongside the 0° mark.
– Retighten the screw again.

Transport

(see figure Y)
– Bring the machine into the transport posi-
tion.
– Remove the extension bars.
– Carry the machine by the transport handle 22
or hold it by the recessed grips 62 on the
sides of the saw table.
¢ The power tool should always be carried by
two persons in order to avoid back injuries.
¢ When transporting the power tool, use only
the transport devices and never use the
protective devices.

Maintenance and Service

Maintenance and Cleaning

¢ Before any work on the machine itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
1 609 929 J60 | (29/11/07)
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean.
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.
Clean the roller 19 and the lighting and laser
unit (55, 24) regularly.
To clean the laser unit, pull the laser protection
cap 63 outward and remove any dust using a
brush. (see figure Z)

Accessories

Dust bag set . . . . . . . . . . . . . . . . 2 605 411 035
Extension bars . . . . . . . . . . . . . . 2 607 001 911
Saw blades for wood and plate materials, pan-
els and strips/mouldings
Saw blade 254 x 30 mm, 40 teeth
. . . . . . . . . . . . . . . . . . . . . . . . . 2 608 640 435
Saw blade 254 x 30 mm, 60 teeth
. . . . . . . . . . . . . . . . . . . . . . . . . 2 608 640 436
Spare parts
Quick-action clamp . . . . . . . . . 1 609 203 P95
Base unit . . . . . . . . . . . . . . . . . 1 609 203 P96
Insert plate. . . . . . . . . . . . . . . . 1 609 203 P97
Set of carbon brushes . . . . . . . . 1 609 203 J13
Bosch Power Tools