Bosch PCM 10 Notice Originale page 45

OBJ_BUCH-573-001.book Page 45 Thursday, November 29, 2007 9:23 AM
Adjusting: (see figure T3)
– Loosen the knurled screw 36.
– Pull out the Allen key 34.
– Turn the set screw 37 (horizontal laser posi-
tioning) and/or 35 (vertical laser positioning)
with the Allen key 34 until the laser beam is
flush with the cutting line on the workpiece
over the complete length.
– Carefully tighten the knurled screw again.
Setting the Standard Bevel Angle 0° (Vertical)
– Bring the machine into the transport posi-
tion.
– Turn the saw table 14 until it engages at 0°.
Checking: (see figure U1)
– Set an angle gauge to 90° and place it on the
saw table 14.
The leg of the angle gauge must be flush with
the saw blade 21 over the complete length.
Adjusting: (see figure U2)
– Loosen the clamping lever 26.
– Loosen the lock nut of the stop screw 17 us-
ing a commercial box-end or open-end span-
ner (size 10 mm).
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever 26 again.
– Afterwards, retighten the lock nut of the stop
screw 17 again.
In case the angle indicator 54 is not in a line with
the 0° mark of the scale 59 after the adjust-
ment, loosen the screw 60 using a commercial
Phillips screwdriver and align the angle indica-
tor along the 0° mark.
Bosch Power Tools
Setting the Standard Bevel Angle 45°
(Vertical)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 14 until it engages at 0°.
– Release the clamping lever 26 and tilt the
tool arm leftward to the stop (45°) by the
handle 2.
Checking: (see figure V1)
– Set an angle gauge to 45° and place it on the
saw table 14.
The leg of the angle gauge must be flush with
the saw blade 21 over the complete length.
Adjusting: (see figure V2)
– Loosen the lock nut of the stop screw 18 us-
ing a commercial box-end or open-end span-
ner (size 10 mm).
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever 26 again.
– Afterwards, retighten the lock nut of the stop
screw 18 again.
In case the angle indicator 54 is not in a line with
the 45° mark of the scale 59, firstly check the 0°
setting for the bevel angle and the angle indica-
tor again. Then repeat the adjustment of the 45°
bevel angle.
Aligning the Fence
– Bring the machine into the transport posi-
tion.
– Turn the saw table 14 until it engages at 0°.
Checking: (see figure W1)
– Set an angle gauge to 90° and place it on the
saw table 14 between the fence 7 and the
saw blade 21.
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting: (see figure W2)
– Loosen all Allen screws 28 with the Allen key
provided.
– Turn the fence 7 until the angle gauge is flush
over the complete length.
– Retighten the screws again.
1 609 929 J60 | (29/11/07)
English | 45