Delivery Scope - Bosch PCM 10 Notice Originale

OBJ_BUCH-573-001.book Page 38 Thursday, November 29, 2007 9:23 AM
38 | English
Assembly
¢ Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.

Delivery Scope

Please also observe the repre-
sentation of the delivery scope
at the beginning of the operat-
ing instructions.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Chop and mitre saw with premounted saw
blade
– Dust bag 20
– Locking knob 12
– Extension bar 6 (2x)
– Fastening kit for extension bar 39
(2 U-profiles with screws)
– Saw-table extension 5
– Length stop 38
– Quick-action clamp 48
– Allen key/Phillips screwdriver 29
– Batteries (3x, size AAA, 1,5 V)
for machine versions with base unit:
– Base unit 41
(16 Profiles, 4 end caps)
– Fastening kit for base unit 42
(24 screws with nuts for assembly, 4 screws
with nuts for fastening of the machine, 4
washers)
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
1 609 929 J60 | (29/11/07)
Mounting Individual Components
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material from the ma-
chine and the accessories provided.
– For easier working when mounting the sup-
plied product features, please observe that
the machine is in the transport position.
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Angle gauge
– Box-end or open-end spanner (size 12 mm)
for assembly of the base unit
– Box-end or open-end spanner (size 10 mm)
for basic adjustment of the bevel angles (ver-
tical)
Mounting the Saw Table Extension and the
Length Stop
(see figure A)
The saw table extension 5 and the length stop
38 can be positioned left or right from the ma-
chine.
– Mount the saw table extension and the
length stop to the requested extension bar 6
as required and tighten the corresponding
wing nut.
Mounting the Extension Bars
(see figure A)
For mounting, use the extension-bar fastening
kit 39. (2 U-profiles with screws)
– Tilt the power tool in such a manner that the
extension bars can be affixed to the bottom
side of the saw-table casing.
– Hold a U-profile over a casing fin 40 so that
the drill holes of both parts are in alignment.
– Insert an extension bar through the drill
holes 16, the U-profile and the casing fins to
the stop.
– Tighten the screw of the U-profile to secure
the extension bar.
– Repeat the work steps for the second exten-
sion bar on the other side of the saw-table
casing.
Bosch Power Tools