Declaration Of Conformity; Delivery Scope - Bosch PCM 8 S Notice Originale

40 | English

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61029,
EN 60825-1 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until
28 Dec 2009), 2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 27.11.2007
Assembly
¢ Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.

Delivery Scope

Please also observe the represen-
tation of the delivery scope at the
beginning of the operating instruc-
tions.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Sliding mitre saw with premounted saw
blade
– Dust bag 1
– Locking knob 13
– Extension bar 19 (2x)
– Fastening kit for extension bar 40
(2 U-profiles with screws)
– Saw-table extension 39
– Length stop 38
1 609 929 U68 | (23/10/09)
Dr. Eckerhard Strötgen
Head of Product
Certification
– Quick-action clamp 49
– Allen key/Phillips screwdriver 20
– Batteries (3x, size LR03, 1,5 V)
for machine versions with base unit:
– Base unit 42
(16 Profiles, 4 end caps)
– Fastening kit for base unit 43
(24 screws with nuts for assembly, 4 screws
with nuts for fastening of the machine, 4
washers)
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Mounting Individual Components
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material from the ma-
chine and the accessories provided.
– For easier working when mounting the sup-
plied product features, please observe that
the machine is in the transport position.
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Angle gauge
– Box-end or open-end spanner (size 12 mm)
for assembly of the base unit
– Box-end or open-end spanner (size 14 mm)
for the lock nuts of the depth stop
– Box-end or open-end spanner (size 10 mm)
for basic adjustment of the bevel angles (ver-
tical)
Bosch Power Tools