Bosch PCM 8 S Notice Originale page 45

– Align the cutting mark on your workpiece
with reference to the right-hand edge of the
laser line.
Before sawing, check if the cutting line is still in-
dicated correctly (see "Adjusting the Laser",
page 46). The laser beam, as an example, can
misadjust due to vibrations after intensive use.
Position of the Operator (see figure O)
¢ Do not stand in a line with the saw blade in
front of the machine. Always stand aside of
the saw blade. This protects your body
against possible kickback.
– Keep hands, fingers and arms away from the
rotating saw blade.
– Do not cross your arms when operating the
tool arm.
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Mitre/Bevel Angle
Horizontal Vertical
0°
45°
0°
45°
Minimal workpiece sizes
(= all workpieces that can be clamped left or
right from the saw blade with the provided
quick-action clamp 49):
160 x 40 mm (length x width)
Sawing without Slide Movement (Cutting Off)
(see figure P)
– For cuts without slide movement (small
workpieces), loosen the locking screw 32 in
case it is tightened. Slide the tool arm to the
stop in the direction of the fence 10 and
retighten the locking screw 32.
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Set the desired mitre angle.
– Switch on the machine.
– Press button 4 and guide the tool arm slowly
downward with handle 5.
Bosch Power Tools
Height x Width
[mm]
0° 70 x 282 mm
0° 70 x 200 mm
45° 35 x 282 mm
45° 35 x 200 mm
– Saw through the workpiece applying uniform
feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Sawing with Slide Movement
– For cuts using the slide device 25 (wide
workpieces), loosen the locking screw 32 in
case it is tightened.
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Set the desired mitre angle.
– Pull the tool arm away from the fence 10 far
enough so that the saw blade is in front of
the workpiece.
– Switch on the machine.
– Press button 4 and guide the tool arm slowly
downward with handle 5.
– Press the tool arm in the direction of the
fence 10 and saw through the workpiece ap-
plying uniform feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Sawing Workpieces of the Same Length
(see figure Q)
The length stop 38 can be used for easily sawing
workpieces to the same length.
– Loosen wing nut 54 and position the length
stop to the requested distance to the saw
blade.
– Tighten the wing nut again.
– Position the workpiece against the stop.
Check again with the cutting line marked by
the laser if the length stop is positioned cor-
rectly.
– Saw this and the other workpieces to the
same length according to the work steps in
the section "Sawing".
English | 45
1 609 929 U68 | (23/10/09)