Bosch PCM 8 S Notice Originale page 42

42 | English
The dust/chip extraction can be blocked by
dust, chips or workpiece fragments.
– Switch the machine off and pull the mains
plug from the socket outlet.
– Wait until the saw blade has come to a com-
plete stop.
– Determine the cause of the blockage and cor-
rect it.
Integrated Dust Extraction (see figure F)
– Mount the dust bag 1 onto the sawdust ejec-
tor 2.
During sawing, the dust bag must never come in-
to contact with the movable machine parts.
Always empty the dust bag in good time.
External Dust Extraction
For dust extraction, a vacuum hose (size
Ø 36 mm) can also be connected to the dust
ejector.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Changing the Tool (see figures G1
¢ When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Use only saw blades whose maximum permitted
speed is higher than the no-load speed of the
power tool.
Use only saw blades that correspond with the
characteristic data given in these operation in-
structions and that are tested and marked in ac-
cordance with EN 847-1.
Removing the Saw Blade
– Bring the power tool into the working posi-
tion.
– Pull the transport safety-lock 35 all the way
outward and turn it by 90°. Allow the trans-
port safety-lock to engage in this position.
The tool arm is now locked in the working posi-
tion.
1 609 929 U68 | (23/10/09)
– Turn the Allen screw 45 with the Allen key 20
provided while at the same time pressing the
spindle lock 44 until it engages.
– Hold the spindle lock 44 pressed and un-
screw the Allen screw 45 in clockwise direc-
tion (left-hand thread!).
– Remove the clamping flange 46.
– Press button 4 and tilt back the retracting
blade guard 7 to the stop.
– Hold the retracting blade guard in this posi-
tion and remove the saw blade 8.
– Slowly guide the retracting blade guard
downward again.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Press button 4, tilt back the retracting blade
guard 7 to the stop and hold it in this posi-
tion.
– Place the new saw blade onto the interior
clamping flange 47.
¢ When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
G4)
–
– Slowly guide the retracting blade guard
downward again.
– Place on the clamping flange 46 and the Allen
screw 45. Press the spindle lock 44 until it
engages and tighten the Allen screw turning
in anticlockwise direction.
– For working afterwards, the tool arm must be
released again. For this, loosen the trans-
port-safety lock 35 by pulling it outward and
turning by 90°.
Bosch Power Tools