Maintenance And Service; Maintenance And Cleaning; Accessories - Bosch PCM 8 S Notice Originale

48 | English
Adjusting: (see figure W2)
– Loosen all Allen screws 33 with the Allen key
20 provided.
– Turn the fence 10 until the angle gauge is
flush over the complete length.
– Retighten the screws again.
Aligning the Angle Indicator (Horizontally)
(see figure X)
– Bring the machine into the transport posi-
tion.
– Turn the saw table 17 until it engages at 0°.
Checking:
The centre line of the angle indicator 14 must be
in line with the 0° mark of the scale 15.
Adjusting:
– Loosen the screw 65 using a commercial
Phillips screwdriver and align the centre line
of the angle indicator alongside the 0° mark.
– Retighten the screw again.
Transport (see figure Y)
Before transporting the power tool, the follow-
ing steps must be carried out:
– Bring the machine into the transport posi-
tion.
– Remove all accessories that cannot be
mounted firmly to the power tool.
– Carry the machine by the transport handle 26
or hold it by the recessed grips 34 on the
sides of the saw table.
¢ The power tool should always be carried by
two persons in order to avoid back injuries.
¢ When transporting the power tool, use only
the transport devices and never use the
protective devices.
1 609 929 U68 | (23/10/09)

Maintenance and Service

Maintenance and Cleaning

¢ Before any work on the machine itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean.
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.
Clean the roller 9 and the lighting and laser unit
(24, 23) regularly.

Accessories

Dust bag set . . . . . . . . . . . . . . . . 2 605 411 222
Extension bars . . . . . . . . . . . . . . 2 607 001 978
Saw blades for wood and plate materials, pan-
els and strips/mouldings
Saw blade 216 x 30 mm,
48 teeth . . . . . . . . . . . . . . . . . . . 2 608 640 430
Saw blade 216 x 30 mm,
24 teeth . . . . . . . . . . . . . . . . . . . 2 608 640 429
Bosch Power Tools