Technical Data; Noise/Vibration Information - Bosch PCM 8 S Notice Originale

61 Set screw for horizontal laser positioning
62 Set screw for vertical laser positioning
63 Scale for bevel angle (vertical)
64 Screw for angle indicator (vertical)
65 Screw for angle indicator (horizontal)
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.

Technical Data

Sliding Mitre Saw
Article number
Rated power input
Rated voltage
Frequency
No-load speed
Laser type
Laser class
Weight according to
EPTA-Procedure
01/2003
Protection class
Permissible workpiece dimensions (maximal/minimal)
see page 45.
Starting cycles generate brief voltage drops. Interfer-
ence with other equipment/machines may occur in case
of unfavourable mains system conditions. Malfunctions
are not to be expected for system impedances below
0.24 ohm.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Mounting hole diameter
Bosch Power Tools
PCM 8 S
3 603 L02 0..
W 1200
V 230
Hz
-1
min 5200
650 nm, < 1 mW
kg 18.7
mm 210
mm 1.4–2.0
mm

Noise/Vibration Information

Measured sound values determined according
to EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 98 dB(A);
Sound power level 111 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 61029:
Vibration emission value a
tainty K =1,5 m/s
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 61029 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
50
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
2
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
/II
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
30
English | 39
2
=3,5 m/s
h
2
.
1 609 929 U68 | (23/10/09)
, Uncer-