Transport Safety - Bosch PCM 10 Notice Originale

OBJ_BUCH-573-001.book Page 40 Thursday, November 29, 2007 9:23 AM
40 | English
Removing the Saw Blade
– Bring the power tool into the working posi-
tion.
– Pull the transport safety-lock 27 all the way
outward and turn it by 90°. Allow the trans-
port safety-lock to engage in this position.
The tool arm is now locked in the working posi-
tion.
– Turn the Allen screw 44 with the Allen key 29
provided while at the same time pressing the
spindle lock 43 until it engages.
– Hold the spindle lock 43 pressed and un-
screw the Allen screw 44 in clockwise direc-
tion (left-hand thread!).
– Remove the clamping flange 45.
– Press button 1 and tilt back the retracting
blade guard 4 to the stop.
– Hold the retracting blade guard in this posi-
tion and remove the saw blade 21.
– Slowly guide the retracting blade guard
downward again.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Press button 1, tilt back the retracting blade
guard 4 to the stop and hold it in this posi-
tion.
– Place the new saw blade onto the interior
clamping flange 46.
¢ When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Slowly guide the retracting blade guard
downward again.
– Place on the clamping flange 45 and the Allen
screw 44. Press the spindle lock 43 until it
engages and tighten the Allen screw turning
in anticlockwise direction.
– For working afterwards, the tool arm must be
released again. For this, loosen the trans-
port-safety lock 27 by pulling it outward and
turning by 90°.
1 609 929 J60 | (29/11/07)
Operation
¢ Before any work on the machine itself, pull
the mains plug.

Transport Safety

(see figure H)
The transport safety-lock 27 enables easier han-
dling of the machine when transporting to vari-
ous working locations.
Releasing the Machine (Working Position)
– Push the tool arm by the handle 2 down a lit-
tle in order to relieve the transport safety-
lock 27.
– Pull the transport safety-lock 27 all the way
outward and turn it by 90°. Allow the trans-
port safety-lock to engage in this position.
– Guide the tool arm slowly upward.
Securing the Machine (Transport Position)
– To lock the saw table 14, tighten the locking
knob 12.
– Press button 1 and tilt down the tool arm by
the handle 2.
– Pull the transport safety-lock 27 all the way
outward and turn it by 90°. Allow the trans-
port safety-lock to engage in this position.
The tool arm is now securely locked for trans-
port.
Extending the Saw Table
(see figure I)
Long workpieces must be underlaid or support-
ed at their free end.
– Loosen the wing nut 47 and pull the saw ta-
ble extension 5 on the extension bar outward
to the distance required.
– Tighten the wing nut again.
Bosch Power Tools