Arktic 226568 Mode D'emploi page 7

Note:
• If no button is pressed within 30 seconds, the
newly set temperature will be stored automati-
cally.
Switch the light ON/OFF
• Press 1b. button to switch ON the light.
Loading the appliance
• Always let the appliance reach the set tempera-
ture before placing or beverages inside the ap-
pliance. Check the cooling temperature display
and additionally put hand into the compartment
to feel the actual temperature.
• Always cool down the beverages to their intended
temperature (< 6 °C) before storing in the appli-
ance.
Defrost
• The appliance will start defrost process automat-
ically for every 6 hours.
Shelf height adjustment
• The height of each shelf can be adjusted.
Installation instructions
• Remove the appliance from the carton box, then
remove the external and internal packaging and
wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages, DO
NOT use the appliance. Please contact supplier
(See ==> Warranty).
• Let the appliance stand upright for about 2 hours.
This is to reduce the malfunction of the cooling
system from improper handling during transpor-
tation.
• Clean interior surface with warm water and soft
cloth. (See ==> Cleaning and Maintenance).
• The temperature setting ranges from 2°C to
10°C.
• Press 1b. button again to switch OFF the light.
• Distribute the food evenly with sufficient sur-
rounding spacings go ensure proper air circula-
tion.
• Do not exceed the maximum shelf load stated in
the technical specification.
• Ensure the doors are always properly shut and
reduced the times of opening doors to minimum.
• When def indicator is ON, the appliance is under
defrost process.
• Adjust the height of each shelf according to the
height of the items.
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
• Optimum working ambient temperature is be-
tween 16°C and 30°C. Otherwise, the functional-
ity will be limited.
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 10 cm around the appli-
ance. Do not block the ventilation holes.
• For energy savings, always make sure the door
is closed.
EN
7