General Information - Gaggenau AC250121 Notice D'utilisation Et De Montage

The permanent electrical installation must only
▶
be wired by a professional electrician. We recom-
mend installing a residual-current circuit breaker
(RCCB) in the appliance's power supply circuit.
Sharp-edged components inside the appliance may
¡
damage the connecting cable.
Do not kink or trap the connecting cable.
▶
The connection data can be found on the rating
¡
plate inside the appliance.
To see the rating plate, remove the grease filter.
¡
The connecting cable is approx. 1.30 m long.
¡
This appliance complies with the EC interference
¡
suppression regulations.
The appliance corresponds to protection class 1.
¡
Therefore, only use the appliance with a protective
earth connection.
Do not connect the appliance to the power supply
¡
during installation.
Only a licensed professional may connect appli-
¡
ances without plugs. They are subject to the require-
ments of the local electricity provider.

General information

The appliance finds it more difficult to draw in the
¡
cooking vapours the further away they are from the
hob. Therefore maintain a distance of at least
700 mm and no more than 1500 mm.
To optimally detect the cooking vapours, install the
¡
appliance in the middle of the hob.
In order to freely access the appliance for servicing,
¡
select an easy-to-reach installation site.
The surfaces of the appliance are sensitive. Avoid
¡
damaging them during installation.
Installation
Checking the ceiling
Check whether the ceiling is horizontal and ad-
1.
equately load-bearing.
The max. weight of the appliance is 40 kg.
Do not fit the appliance directly onto plasterboard
(or similar lightweight materials) in a suspended
ceiling.
Drill the hole depth in accordance with the length of
2.
the screws.
Install the appliance with a fixing material which is
3.
sufficiently stable and has been adjusted accord-
ingly for both the structural conditions and the
weight of the appliance.
Check the cut-out area for existing cables of other
4.
appliances.
Preparing the ceiling
Ensure that the stability of the ceiling is guaranteed
1.
after the cut-outs have been made.
Cover the hob to prevent damage.
2.
Saw a cut-out into the ceiling.
3.
x
x y
487 ±1 888 ±1
487 ±1 1188 ±1
Remove any shavings.
4.
Preparing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
Tilt the transport lock slightly upwards and carefully
1.
pull it upwards and out at an angle.
Remove polystyrene residues from the interior of the
2.
appliance.
Remove the grease filters.
3.
To avoid causing damage, do not bend the grease
filters.
Installing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
¡
edges.
Wear protective gloves.
▶
The appliance is heavy.
¡
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.
▶
Installation instructions en
z
y
z
16 – 50
16 – 50
37